User's Manual
Operations
1． LinkingLEDStripControllerwithYoSmartLED
StripRemoteControllerorYoSmartHub
Before Operation:
a) LED Strip Controller should be connected to a power source;
Operating Steps:
a) Use the LED Strip Remote Controller or the YosmartHub start the Linking
command;
b) Press the LED Strip Controller's button (LINK) for more than seconds until
the green indicator LED flashes, then release the button;
c) After the linking completes successfully, the green indicator LEDwill stop
flashing and off;
Precautions:
a) After pressing "LINK" button to enter linking status, linking must be
completed within four minutes. After four minutes, the device will
automatically exit the linking mode and the green LED will stop flashing.
b) In the 4 minutes time out period, press "LINK" button once to exit linking
mode.
2． UnlinkLEDStripController
Before Operation: