user manual

KingTech Turbines "F" series, Kero Start operating guide:

1. Please install the engine on a simple stand to familiarize the components and

starting sequence

2. For ECU battery pack, please use 2S 7.4V Lipo at least 4000 mAh and 15C

3. When Learning RC, please disconnect ECU battery to avoid a false start

4. A fully charged 2S lipo pack has a voltage of 8.4V, please be prepared to

charge the battery when its residual voltage drops down to 7.8V to avoid

damage to the battery and failed start. If the combustion chamber of the

engine is not properly cooled after a fail start, a wet start may or may not

occur on the subsequent attempt, please refer to below to avoid a wet start.

5. If and when your engine fails to start, there may still be residual flame and

fuel remain in the combustion chamber, please do the following to avoid a wet

start:

a. Stick Low, Trim Low

b. Move Stick forward to activate rotor to further cooling the chamber.

c. wait at least 5 minutes before resuming

Page 37