user manual

Radio: Programming the transmitter throttle and trim throws, and setting of throttle

curve.

Run: Set the parameters used during engine run.

It is recommended to program the learn RC first.

Learn R/C. Teach the ECU to the R/C System

Learn RC (throttle stick and trim travel) on Xicoy ECU just doesn’t get easier. First,

please set stick low and trim low on transmitter and power on transmitter, and

receiver. Power on ECU plug in GSU, scroll and select “Radio” then just follow

directions on the screen.

Once you have done all steps correctly the green LED located directly above the GSU

socket will light up in the ECU when the “Idle” command, (trim and throttle stick set

to idle positions on the transmitter). Lower your throttle trim and the green

LED will go out indicating correct reading of the transmitter engine shut off signal by

the FADEC. On rare occasions, usually when using a Futaba transmitter, it has been

found that the throttle channel sense of movement may require reversing (Servo

reverse) and repeat the transmitter alignment, where JR 12X requires to be at

Normal.

Correct reading of throttle % by the FADEC can be verified in the second screen,

percentage of the throttle position is shown on, 0% in the position of engine stop

(trim and stick down), 100% with stick/trim full up and between 10% and 30% at

idle.

This now completes your radio setup and should only need doing again if the radio

settings in the TX are changed or a different Radio is being used.

Page 24