user manual

changing the data. Main screen, as shown in the picture, give to the user that main

readings from the engine. These are the FADEC status, the EGT (temperature), RPM

and Fuel Pump pulse width (Pw)

In the case of an error, this screen changes to the error screen every 2 seconds.

Pressing the second button from the left (Menu Up) the second information screen is

shown. In the first line you have the measure of the pulse width received from your

RC system, and the relative stick position. Second line shows the voltage of the

battery and the software version. If the current drawn from the battery is higher than

0,5A, then the FADEC display the battery voltage and the battery current in Amperes.

Next menu lets you to choose in four submenus, selected by pressing the button

under of each Heading.

Start: To the parameters used on startup

Info: Information and test menus

Page 23