User's Manual

Power on
Press and Hold “ ” button 2 seconds to power ON.
Power off
Press and Hold “ ” button 2 seconds to power OFF.
Operation
Pairing
The unit will automatically go into “Pairing Mode” when it is
powered ON.
Go into your Bluetooth device settings menu and look for
“S6”.
After the unit has been paired and connected, it will
re-connect automatically when the unit is powered on and
the device is in range.
Press and hold” ”2 seconds bluetooth will be disconnected
Note: Bluetooth Timeout :10 minutes.
Bluetooth Mode
Begin Streaming Music
Press “ ” to start playing music.
Press and Hold “ ” 2 seconds to play the next track.
Press and Hold “ ” 2 seconds to play the previous track.
Press either “ ” or “ ” for volume control.
Hands-Free Function
When the unit is connected and paired to your device, you
can use the hands-free function with its built-in microphone.
Press “ ” to accept a call.
To end a call press “ ”.
Aux-In Mode
Plug in the supplied 3.5 mm audio cable into the unit. The
other end is connected to your device. The unit will
automatically enter the Aux-In mode.
Please note music and volume can be controlled by
your device.
Charging
Attach the USB cable to the unit, and plug into any USB
charger. If the unit is completely discharged, it will take
approximately 4 hours to fully charge.
These three key lights “ ” “ ” “ ” will be breath
lighting when charging, and they will become solid once
fully charged.
Note: There will be a beep when the battery is low and
needs to be recharged.
TWS Wireless Stereo Mode
If you have two pieces S6, you can use TWS function
to achieve wireless stereo combined-playing music.
1.Make sure both S6 are without any Bluetooth
connection.
2.Power on both speakers, and touch each other with the side,
the two speakers will connect automatically with a notifying
tone.
When LED blink on one speaker and keeps solid on
the other one, it means the TWS connection is successful.
3.Then you can search your Bluetooth device and
select “S6”.
4.Touch them again for Bluetooth Disconnection.
5.Press and Hold “ ” button 2 seconds on one of
the units, both units will be powered off.
Unit doesn’t connect
to device
Speaker needs to be connected /
re-paired to device
A tone is heard every
few seconds
Speaker needs to
be recharged
Unit will not power on
Speaker needs to
be recharged
Unit doesn’t control
track(s) / volume
Speaker needs to be in Bluetooth
mode for full control
Unit distorts at
high volume
The devices’ volume
needs to be lowered
Troubleshooting