User's Manual
1)TWS mode:
channel, the other will play only the right channel).
B)Power on both units and press
has connected successfully.
once to answer the call. This will also pause your music. Press the
to reject the call.
To go back the previous track, press the
for more than 1 second.
A)Light with music(under music mode)
C)Breathing light color switch
When U disk plug out , the speaker will turn to Bluetooth mode.
disk plug out , the speaker will turn to Bluetooth mode.
Bluetooth Pairing Procedure
1.Turn on you mobile device and go to the Bluetooth menu.
paring mode.
required, enter 0000.)
True Wireless Stereo (TWS) Func�on
channel, the other will play only the right channel).
Reconnec�ng to a disconnected device
powered on.
Sleeping mode
1.
2.
10 minutes.
AUX mode
2.Connect the other end to the analog audio source.
FCC Statement：
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1)
this device may not cause harmful interference, and 2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try correct the interference by
one
or more of the following measures:
- Reorient the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into and outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void your
authority to operate the equipment.