User's Manual

Operation
Powering On
Press and Hold "ON/OFF" button 2 seconds to power ON, the
Blue LED will start to rapid blink .
If an Aux (3.5 mm) cable is connected to the unit, the Blue LED
will slow blink, the unit is in Aux-In mode.
.
Powering Off
Press and Hold "ON/OFF" button 2 seconds to power OFF
Wireless Mode
Pairing
The unit will automatically go into “Pairing Mode” when it is
powered ON.
Go into your Wireless device settings menu and look for
“KB102H”.
After the unit has paired and connected, it will re-connect
automatically when the unit is powered on and the device
is in range.
Note: Wireless Timeout :10 minutes
Begin Streaming Music
Press “ ” to start playing music
Press and Hold“ ” 2 seconds to play the next track
Press and Hold“ ” 2 seconds to play previous track
Press either “ ” or “ ” for volume control
Making and Receiving Phone Calls
When the unit is connected and paired to your device,
the unit allows you to make or receive phone calls with its
built-in microphone.
Press “ ” to accept a call
To end a call press“ ”
To place a call, simply dial the number or select a contact from
your Wireless device and call
To reject a call, press and hold “ ” for 2 seconds
Aux-In Mode
Plug in the supplied 3.5 mm cable into the unit. The other end is
connected to your device. the Blue LED will slow blink when in
“Aux”mode.
Please note music and volume can be controlled by your device.
Charging
Attach the USB cable to the unit, and plug into any USB charger.
If the unit is completely discharged, it will take approximately 3
hours to fully charge.
The Red LED will illuminate during charging, when it has
completed, the Red LED will turn off.
Note:There will be a beep when the battery is low and needs to
be recharged.
LED Status
Blue LED rapid blink & Blue LED solid Wireless Mode
Blue LED slow blink
Red LED
Aux Mode
Charging
Troubleshooting
Unit doesn’t connect
to device
Speaker needs to be connected/
re-paired to device
A tone is heard every few seconds Speaker needs to be charged
Unit will not power on
Speaker needs to be charged
Unit doesn’t control
track(s)/volume
Speaker needs to be in Wireless
mode for full control
Unit distorts at
high volume
The devices’ volume needs to
be lowered