User's Manual

Introduction

1.ON/OFF/Play/Pause/Phone

2.Next/Volume +

3.Previous/Volume –

4.MIC

5.Micro USB Charging Port

6.Red LED(Charging)

7.Blue LED(Wireless)

Included:

1.Speaker

2.USB Micro Charging Cable

Wireless Speaker Instruction

Manual

3.3.5 mm Audio Cable

4.User Manual

Specifications

Supported Profiles: A2DP, HFP, AVRCP

Wireless Range:33ft (10m)

Dimensions: 180 mm x 55 mm x 55 mm

Battery: Li-Ion 3.7V, 600 mAh

Charging: 5V / 500 mA

KB102H

Thank you for choosing the KB102H as your source for

entertainment! you can use this item with Pads,Phones,

iPods and many types of smartphone to stream music ,

and enjoy handsfree calling.In order to get the best results

when using the device,please read this manual first before using.

FCC ID: N7KKB102H

Model Name: KB102H

PAGE 1
Included: Introduction Wireless Speaker Instruction Manual Thank you for choosing the KB102H as your source for entertainment! you can use this item with Pads,Phones, iPods and many types of smartphone to stream music , and enjoy handsfree calling.In order to get the best results when using the device,please read this manual first before using. FCC ID: N7KKB102H Model Name: KB102H 1.ON/OFF/Play/Pause/Phone 2.Next/Volume + 4 1.Speaker 2.USB Micro Charging Cable 3.3.5 mm Audio Cable 4.User Manual 3.
PAGE 2
Operation Powering On Press and Hold "ON/OFF" button 2 seconds to power ON, the Blue LED will start to rapid blink . If an Aux (3.5 mm) cable is connected to the unit, the Blue LED will slow blink, the unit is in Aux-In mode. . Powering Off Press and Hold "ON/OFF" button 2 seconds to power OFF After the unit has paired and connected, it will re-connect automatically when the unit is powered on and the device is in range.
PAGE 3
FCC Caution. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.