User's Manual

TWS function
1.The speakers are intended to be linked together so as to experience True
Wireless Stereo sound via Bluetooth.
2.First make sure that the speakers do not have an active Bluetooth connection
with a mobile device.
3.Power on both speakers, press the “ ” on one of them to initiate the
automatic pairing mode between the two units, there is tone
after TWS paired.
4.Master(left) unit LED blink in white; Slave(right) unit LED stay
illuminated in blue.
5.Playback function remain accessible in either unit, Phone commands ,
however, they are available only through the master(left) speaker
Bluetooth mode of operation
1.The blinking LED from previous section indicates that the speaker has
entered into the paring mode.
2.Place your mobile device and the speakers not more than 2 meters away
from each other.
3.Set your mobile device to discover the wireless speaker and select “H1”
4.When pairing is successful ,the speaker will confirm with an audible tone
and a solid LED indication,master LED stays solid in white; slave speaker
LED stays solid in blue.
5.Finally to disconnect the speakers from your mobile device, simply press
and hold the BT button to cancel the Bluetooth mode.
Music playback in TWS mode
1.Press “ ” to start and stop audio playback.
2.Press and hold the“ ”button to play the next track.
3.Press and hold the“ ”button to play the previous track.
4.In order to adjust the volume level , briefly press the “ ” or “ ” button.
Turning your speaker on or off in TWS mode
1.To turn the speaker on, press and hold “ ” for 2 seconds on each unit
2.Press and hold “ ”again for 2 seconds to turn a single unit off when
unpaired, however, if the two are linked, then both will be powered off
simultaneously upon pressing the button on the left( master) unit.
3.Every time the speakers are switched on and off, a tone will sound to
indicate in what state each unit currently is.
Note:In TWS mode, only master speaker supports AUX, TWS function, press