0 YEAR MANUFACTURER'S LIMITED WARRANTY All parts of this Kingston Brass faucet are warranted to the original retail purchaser to be free from defects in material and workmanship for a period of Ten(10) years from the date of purchase as shown on the purchaser's receipt. This warranty is limited to defective parts only, labor charges and/or damage resulting from improper installation, repair or replacements, as well as incidental and consequential damages connected therewith are excluded.
Need Tools: Wall Mount Tub Filler with Hand Shower = BEFORE BEGINNING INSTALLATION: 1. Flush plumbing lines to clear any debris. 2. Shut off both supply lines after flushing. Basin Wrench Adjustable Wrench ~~ Teflon Tape Silicone Sealant Screwdriver SOR: INA: RIT XT 5. Place a washer between the side hole of 6. Tum on both hot and cold valves, let 1. Shut off main water supply valve before 2. Place flange to elbow and connect the installation elbow to the supply lines.
KINGSTON KITCHEN BATH Double Offset Bath Supply Before starting the installation: Straight supply lines are designed to ba installed on tubs that are configured for deck mount faucets, and should be installed at the same center to center distance as that of the tub faucet holes, the supply lines should be installed in a plumb vertical position before starting the installation we recommend: © That you have the supply lines and faucet at the job site prior to preparing the rough-in water: "Suppl.
KINGSTON KITCHEN & BATH INSTALLATION INSTRUCTIONS Straight Stop Instructions: Apply thread sealant tape to threads (1). Screw valve body (2) onto pipe (3). Place nut (4), metal washer (5) and rubber washer (6) on tube (7). Insert tube (7) into valve. Wrench tighten nut (4) onto valve. Stop any leaks by tightening nuts slightly. ooh wn ~No on www.kingstonbrass.
KINGSTON KITCHEN & BATH www.kingstonbrass.
KINGSTON KITCHEN Ba Bath INSTALLATION INSTRUCTIONS Brass Tub Bath Drain Note: Observe all local plumbing and building codes. TOOLS REQUIRED Drain Wrench Adjustable Wrench Teflon Tape Silicone Sealant Screwdriver Pipe Wrench INSTALLATION INSTRUCTIONS: 1. Place rubber washer (10) onto waste tube (9) and set them under the tub. 2. Apply Teflon tape on strainer thread and a bead of silicone Rubber Gasket (3) "a sealant under waste strainer (11) and thread into waste Cover Plate (2) Ny tube (9).
