Parts List For Moen Universal Trim Kit A1 ‐ Large Sleeve A2 ‐ Sleeve A3 ‐ Sleeve B ‐ #8‐32 × 1‐3/4" Screw C ‐ Faceplate D1 ‐ Faceplate Insert D2 ‐ Faceplate Insert D3 ‐ Faceplate Insert F ‐ Faceplate Gasket E1 ‐ Sleeve Gasket E2 ‐ Sleeve Gasket G ‐ Diverter Plug I ‐ Bushing J ‐ Stop K ‐ Handle Adapter O ‐ Lever Handle P ‐ #6‐32 ×5/8" Screw Q ‐ Acrylic Handle H ‐ Diverter Foam Gasket L ‐ #10‐24 ×1/2” M ‐ Handle Adapter Screw R ‐ Handle Cap S ‐ #10‐24 × 1‐1/4" Screw N ‐ Adapter T ‐ Lock W
Installation Instructions for Moen Universal Trim Kit Identification of Correct Valve (figure 1) Before removing the old tub/shower faucet trim or handle, determine which valve body you have. To turn the water from OFF to ON: 1. Do you rotate the handle from right to left (counter‐clockwise)? If you Rotate the handle from right to left, you have valve type A (Posi Temp R ) 2.
Installation Instructions for Moen Universal Trim Kit Valve Type A Installation (figures 6 – 8) 1. Slide stem washer over valve stem (figure 6). 2. Insert bushing into sleeve and then insert stop into bushing. Note: This is a temperature limiting device. Rotate the stop clockwise and press into place to limit the output of hot water. ! THIS DOES NOT REDUCE THE NEED TO LOWER FIGURE 6 THE TEMPERATURE OF THE WATER HEATER TO PREVENT SCALDING! Determine type of handle to use.
