P-Trap Installation: Lavatory Faucet Hole oO” 4. Flange i 1. Coupling Nt —© 3. Coupling Nut 6. Horizontal Leg 2. Black Washer: 5. Black Washer The lips of washers 7.P Trap should be facing down. Insert horizontal leg (6) into wall drain stub-out. Remove coupling nut {1} and black washer (2) from the P-trap (7) . Insert coupling nut (1) and black washer (2) onto the tailpiece (8), make sure the lip of washer is facing down. Attach P-rap to the tailpiece (8).
FAUCET INSTALLATION INSTRUCTIONS Console Sink Legs Before Installation : 1. Before beginning the installation of your console pedestal basin, it is important to identify the type of wall where the pedestal will be installed and prepare the installation location accordingly. 2. Install an anchoring brace in the wall prior to installing the drywall, this can piece of wood that will fit between the two studs, then install drywall and finish as usual.
FAUCET INSTALLATION INSTRUCTIONS Vanity Tops and Console Sink Before Installation : 1. Prior the installation, unpack your new Kingston Brass product and inspect it keep the product in its original package until you are ready to install it. 2. Shut the water supply off when replacing an existing fixture. Preparation of the floors and walls, including all additional wall supports, maybe required. Observe all local plumbing and building codes. Do not install this fixture alone.
FAUCET INSTALLATION INSTRUCTIONS L Shape Mounting Bracket Need Tools: Phillips Screwdriver Hammer Silicone Pencil Drill Note: 1. 2" x6" lumber or larger wood bracing needs to be added to the wood wall structure for the bracket supporting. 2. If the basin is going fo be installed on console base which has 4 legs standing on floor, the bracket could be optional. Installation: Once unit has been assembled place at the desired location.
