oh wn KINGSTON KITCHEN & BATH INSTALLATION INSTRUCTIONS Angle Stop Instructions: Place nut (4) and ring (3) on tube (2). Insert tube (2) into valve. Wrench tighten nut (4) onto valve. Repeat steps 1 through 3 with the other side. Stop any leaks by tightening nuts slightly. www.kingstonbrass.
KINGSTON KITCHEN & BATH INSTALLATION INSTRUCTIONS Bottle-Trap Instructions: Remove horizontal leg and slip joint nut from bottle trap. Apply Teflon to all exposed threads. Insert slip joint nut (2) and waste cover (3) onto horizontal leg (5). Insert horizontal leg into wall waste opening, do not tighten. Insert slip joint nut (1) and Holder (8) onto tail piece (7). Attach bottle trap (6) to tail piece and hand tighten slip joint nut (1).
KINGSTON BITCH GR Ba INSTALLATION INSTRUCTIONS Push Drain with or without Overflow Basin Wrench Adjustable Wrench Teflon Tape Silicone Sealant Screwdriver INSTALLATION: 1. Remove the lock nut (7), washer (6) and rubber gasket (5) from the drain body (3). 2. Insert the drain assembly downward through the drain opening on the bottom of sink. So the tailpiece (8) and the outer threads of drain body (3) can go all the way through the drain opening and expose beneath the sink. 3.
