Use and Care Manual

wall using a level and mark a reference line below the piece. Next, trace a line with the level from
one end of the wall to the other starting from this reference.
• Remove the protective film from the adhesive strips on the back of the first board and place it
following the reference line. Stick the top of the board first, then the bottom and press firmly for
10 seconds.
• Repeat for each piece along the row.
• If necessary, cut the boards with a hand saw or circular saw, taking care to properly measure so
that they fit perfectly to the adjacent pieces. Before removing the adhesive strips, test each
board in place, because once it is stuck, the board cannot be moved.
• We recommend installing boards from left to right, and taking the trim left over from the last
piece of a row to start the next.
• For a natural finish, take care to layer the joints from one row to the next so that they don’t
form a vertical line. We recommend offsetting the joints by at least six inches between rows (see
first picture in the section “Installation Styles” below).
• Once all the boards are installed, apply pressure using a rubber mallet and wooden plank so as
not to damage the boards.
Installation Tips
• Mix several board colours from among the self-adhesive wood wall panel for a unique and
vintage look.
• Follow one of the many installation styles suggested or create a personalized design for a
made-to-measure result.
Installation Style
Maintenace:
Do not apply water to the surface. Use a hardwood cleaner or a soft and dry brush
Caution:
PROPOSITION 65 WARNING: Drilling, sawing, sanding or machining wood products generates
wood dust, a substance known to the State of California to cause cancer. Use a respirator or other
safeguards to avoid inhaling wood dust. Installation