Instructions / Assembly

5.Unscrew the red igniter button on the control
box and insert the AA battery (17) with the
POSITIVE end facing upward.Then attach the
control box (2) underneath the middle plate (3)
with screws (19).
6.Carefully put the glass tube (7) up through the center
of the hole in the upper plate (4).Make sure the rubber
ring (18) is attached on the lower end of the glass tube.
Now place the glass tube through the hole on the middle
plate (3). Check to ensure the glass tube covers the center
hole of the middle plate.
- 8 -
Hardware Used: 1x AA Battery
4x Screws
Hardware Used: 1x Rubber Ring