Instructions / Assembly

Step 1
Place all parts on a clean and soft
surface
Step 2
Attach the front and back Legs (⑥,⑦) to the Studs on
the Chair Seat (⑤) using 8xWahers and 8xNuts
(A,B,C).Tighten the Nuts using the wrench & tighten.
Step 3
Attach the Backrest (④) to the Chair
Seat (⑤) using 2xWashers and
2xNuts (A,B,C).Tighten the Nuts using
the wrench ..DO NOT over tighten.
Step 4
Attach the Right and Left Arm(⑧,⑨) ,using 1xthe studs
(D) and 2xwasher,nuts (E,F,G) ,DO NOT over tighten .and
then using2x Studs (H) and Wahers and Nuts
(E,F,G).Adjust to a correct place ,then tighten D&H.
Step 5
Adjust the pre-installed Rubber Pad
(L) until the chair is level with the
ground , Upon completion of full
assembly and bolted up-all screws
can be tightened down.Tighten all the
nuts and cover them with nut
caps(I&J).
4
C
D
H