Instructions / Assembly

Step 1:Place all parts on a clean and soft surface.

Step 2: Attach the table legs(②) using the stud(K)x3 on the table top,using washers and

nuts(A,B,C),Tighten using a wrench and a washer(as a one line screw driver)(Fig1)

Step 3:Attach the leg support (③)to the table leg (②) using 2xstuds(D),washers,and

nuts(E,F,G).Tighten the nuts using the wrench.DO NOT over tighten(Fig.2)

Step 4:Turn over the table and tighten all nuts with wrench.Adjust the preassembled rubber pad

(L) at the end of each table leg until the table is level with the ground.(Fig 3) Tighten all the

nuts and cover them with nut caps(I&G).

Step 1

Place all parts on a clean and soft

surface

Step 2

Attach the front and back Legs (⑥,⑦) to the Studs on

the Chair Seat (⑤) using 8xWahers and 8xNuts

(A,B,C).Tighten the Nuts using the wrench & tighten.

Fig 1

Fig 2

Fig 3