Instructions / Assembly

Warning and Maintance

1. Do not discard any packaging until you have checked that you have all parts and fittings.

2. Ensure you have enough room for safe assembly. Ensure children and pets are kept out of the

assembly area.

3. We suggest you carry out the assembly on a soft surface like a carpet or the opened box, so

as to avoid scratching the paint.

4. Please note that this products is made of cast metal, you may find some unevenness on the

surface which entirely normal for cast metal and is not a defect.

1. Always lift and carry instead of dragging as dragging can cause damage.

2. Clean with warm water and a lint free cloth.

3. Do not use abrasive or corrosive cleaners.

ASSEMBLY INSTRUCTIONS

PLEASE READ ALL INSTRUCTIONS THOROUGHLY BEFORE STARTING ASSEMBLY

PARTS LIST

PAGE 1
Warning and Maintance 1. Do not discard any packaging until you have checked that you have all parts and fittings. 2. Ensure you have enough room for safe assembly. Ensure children and pets are kept out of the assembly area. 3. We suggest you carry out the assembly on a soft surface like a carpet or the opened box, so as to avoid scratching the paint. 4.
PAGE 2
PARTS LIST Part No. Description Qty Part No.
PAGE 3
K A B Fig 1 C D E Fig 2 F G Fig 3 Step 1:Place all parts on a clean and soft surface. Step 2: Attach the table legs(②) using the stud(K)x3 on the table top,using washers and nuts(A,B,C),Tighten using a wrench and a washer(as a one line screw driver)(Fig1) Step 3:Attach the leg support (③)to the table leg (②) using 2xstuds(D),washers,and nuts(E,F,G).Tighten the nuts using the wrench.DO NOT over tighten(Fig.2) Step 4:Turn over the table and tighten all nuts with wrench.
PAGE 4
C Place all parts on a clean and soft surface Step 3 Attach the front and back Legs (⑥,⑦) to the Studs on the Chair Seat (⑤) using 8xWahers and 8xNuts (A,B,C).Tighten the Nuts using the wrench & tighten. Step 4 D H Attach the Backrest (④) to the Chair Attach the Right and Left Arm(⑧,⑨) ,using 1xthe studs Seat (⑤) using 2xWashers and (D) and 2xwasher,nuts (E,F,G) ,DO NOT over tighten .and 2xNuts (A,B,C).Tighten the Nuts using then using2x Studs (H) and Wahers and Nuts the wrench ..DO NOT over tighten.