Pre-Delivery/Install Checklist

The hardware included with this item is meant for
drywall or stud mounting only. If your walls are
made from concrete, brick or plaster, please
consult your local hardware store for assistance in
selecting the appropriate hardware.
Aluminum Framed Round Mirror
Mounting instructions
Tools: Pencil, Screwdriver,
Measuring Tape, Stud finder
Hardware: TWO Anchors
TWO Screws
Mounting Instructions:
1) Before you get started with the below mounting steps, use a measuring tape measure the distance from
the side edge of the Mirror to the center of a butterfly hanging clip.
2) Determine a desired mounting location. With the help of another person, hold the mirror level against wall
at a desired mounting location. Use a pencil to mark out both sides of the butterfly hook. Place the mirror
aside.
3) Use a stud finder to look for wall stud in the desired installation points. If any of the installation point
aligns with stud, use provided metal screws only. If there is no stud, both the dry wall anchors/metal
screws are required.
4) If a installation point aligns with wall stud, use a Phillips screwdriver and secure a metal screw directly
into the installation point and into the aligned stud. Rotate the screw clockwise until the screw head is
about 3/8 inch from the wall surface.
5) For installation point that do not align with a wall stud, use a Phillips screwdriver to insert the wall anchor.
Do not “push” or drive the anchor into the wall, it is designed to bore into the wall like a drill bit. Slowly
turn the anchor clockwise while applying pressure until the flange just touches the wall. Again, using the
screwdriver, insert a screw into the installed wall anchor and rotate the screw clockwise until the screw
head resides about 3/8” from the wall.
6) After installation of the anchors/screws, raise the Mirror against the wall so that the key-holes are
supported by the screw heads.
Care Instructions: To clean: wipe with a soft, dry cloth. Do not use abrasive or strong chemical
household cleaners. A household glass cleaner may be used for the Mirror
surfaces – spray the cleaner on a clean cloth first and then use the cloth to clean
the Mirror. Do not spray the cleaner directly onto the Mirror or frame surfaces.
Thank you for your purchase
www.kingerhome.com
Use one screw and anchor to hang Mirror from a single mounting point. Stud is not required but
recommend to support this frame. Please visit www.kingerhome.com for installation videos