User Manual

Revision 1.0 Page 60 of 78
nRF24L01+ Product Specification
0B RX_ADDR_P1 39:0 0xC2C2C
2C2C2
R/W Receive address data pipe 1. 5 Bytes maximum
length. (LSByte is written first. Write the number of
bytes defined by SETUP_AW)
0C RX_ADDR_P2 7:0 0xC3 R/W Receive address data pipe 2. Only LSB. MSBytes
are equal to RX_ADDR_P1[39:8]
0D RX_ADDR_P3 7:0 0xC4 R/W Receive address data pipe 3. Only LSB. MSBytes
are equal to RX_ADDR_P1[39:8]
0E RX_ADDR_P4 7:0 0xC5 R/W Receive address data pipe 4. Only LSB. MSBytes
are equal to RX_ADDR_P1[39:8]
0F RX_ADDR_P5 7:0 0xC6 R/W Receive address data pipe 5. Only LSB. MSBytes
are equal to RX_ADDR_P1[39:8]
10 TX_ADDR 39:0 0xE7E7E
7E7E7
R/W Transmit address. Used for a PTX device only.
(LSByte is written first)
Set RX_ADDR_P0 equal to this address to handle
automatic acknowledge if this is a PTX device with
Enhanced ShockBurst™ enabled. See page 75
.
11 RX_PW_P0
Reserved 7:6 00 R/W Only '00' allowed
RX_PW_P0 5:0 0 R/W Number of bytes in RX payload in data pipe 0 (1 to
32 bytes).
0 Pipe not used
1 = 1 byte
…
32 = 32 bytes
12 RX_PW_P1
Reserved 7:6 00 R/W Only '00' allowed
RX_PW_P1 5:0 0 R/W Number of bytes in RX payload in data pipe 1 (1 to
32 bytes).
0 Pipe not used
1 = 1 byte
…
32 = 32 bytes
13 RX_PW_P2
Reserved 7:6 00 R/W Only '00' allowed
RX_PW_P2 5:0 0 R/W Number of bytes in RX payload in data pipe 2 (1 to
32 bytes).
0 Pipe not used
1 = 1 byte
…
32 = 32 bytes
14 RX_PW_P3
Reserved 7:6 00 R/W Only '00' allowed
Address
(Hex)
Mnemonic Bit
Reset
Value
Type Description