Datasheet

SPEC NO: DSAC6763 REV NO: V.1 DATE:MAY/13/2003 PAGE: 1 OF 4

APPROVED : J. Lu CHECKED :Allen Liu DRAWN: X.T.HU

KM-23SGEW-CA

SUPER BRIGHT GREEN

HIGH EFFICIENCY RED

SOT-23 SURFACE MOUNT LED LAMP

Features

lSOT-23 PACKAGE SURFACE MOUNT LED LAMP.

lLOW POWER CONSUMPTION.

lLONG LIFE - SOLID STATE RELIABILITY.

lPACKAGE: 2000PCS / REEL.

Description

The Super Bright Green source color devices are made

with Gallium Phosphide Green Light Emitting Diode.

The High Efficiency Red source color devices are made

with Gallium Arsenide Phosphide on Gallium Phosphide

Orange Light Emitting Diode.

Notes:

1. All dimensions are in millimeters (inches).

2. Tolerance is ±0.25(0.01") unless otherwise noted.

3. Lead spacing is measured where the lead emerge package.

4. Specifications are subject to change without notice.

Package Dimensions

PAGE 1
SOT-23 SURFACE MOUNT LED LAMP KM-23SGEW-CA SUPER BRIGHT GREEN HIGH EFFICIENCY RED Features Description l LOW with Gallium Phosphide Green Light Emitting Diode. l SOT-23 PACKAGE SURFACE MOUNT LED LAMP. POWER CONSUMPTION. l LONG LIFE - SOLID STATE RELIABILITY. l PACKAGE: 2000PCS / REEL. The Super Bright Green source color devices are made The High Efficiency Red source color devices are made with Gallium Arsenide Phosphide on Gallium Phosphide Orange Light Emitting Diode.
PAGE 2
Selection Guide P ar t N o . Dic e SUPER BRIGHT GREEN (GaP) KM-23SGEW-C A Iv (m c d ) @ 20 m A L en s Ty p e HIGH EFFIC IENC Y RED (GaAsP/GaP) Mi n . Ty p . 5 10 5 WHITE D IFFUSED Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value.
PAGE 3
KM-23SGEW-CA Super Bright Green / High Efficiency Red SPEC NO: DSAC6763 APPROVED : J. Lu REV NO: V.1 CHECKED :Allen Liu DATE:MAY/13/2003 DRAWN: X.T.
PAGE 4
KM-23SGEW-CA SMT Reflow Soldering Instructions Number of reflow process shall be less than 2 times and cooling process to normal temperature is required between first and second soldering process. Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) SPEC NO: DSAC6763 APPROVED : J. Lu REV NO: V.1 CHECKED :Allen Liu DATE:MAY/13/2003 DRAWN: X.T.