Datasheet

ManualsBrandsKINGBRIGHT ManualsDisplaysAlphanumeric segment display Yellow 10.16 mm 1.95 V No. of digits: 1

SPEC NO: DSAG7187 REV NO: V.9A DATE: APR/07/2013 PAGE: 1 OF 5

APPROVED: WYNEC CHECKED: Joe Lee DRAWN: Q.M.Chen ERP: 1361000057

SURFACE MOUNT DISPLAY

Part Number: KCPSC04-107 Super Bright Yellow

Features

z 0.4 inch character height.

z Low current operation.

z High contrast and light output.

z Categorized for luminous intensity.

z Mechanically rugged.

z Gray face,white segment.

z Package : 400pcs / reel.

z Moisture sensitivity level : level 2a.

z RoHS compliant.

Description

The Super Bright Yellow device is made with AlGaInP (on

GaAs substrate) light emitting diode chip.

Package Dimensions& Internal Circuit Diagram

Notes:

1. All dimensions are in millimeters (inches), Tolerance is ±0.25(0.01")unless otherwise noted.

2. The specifications, characteristics and technical data described in the datasheet are subject to change without prior notice.

3.The gap between the reflector and PCB shall not exceed 0.25mm

Summary of content (5 pages)

PAGE 1
SURFACE MOUNT DISPLAY Part Number: KCPSC04-107 Super Bright Yellow Features Description z 0.4 inch character height. The Super Bright Yellow device is made with AlGaInP (on z Low current operation. GaAs substrate) light emitting diode chip. z High contrast and light output. z Categorized for luminous intensity. z Mechanically rugged. z Gray face,white segment. z Package : 400pcs / reel. z Moisture sensitivity level : level 2a. z RoHS compliant.
PAGE 2
Selection Guide Part No. Dice KCPSC04-107 Iv (ucd) [1] @ 10mA Lens Type Super Bright Yellow (AlGaInP) Min. Typ. 21000 46000 *5600 *12000 White Diffused Description Common Cathode, Rt. Hand Decimal. Note: 1. Luminous intensity/ luminous Flux: +/-15%. * Luminous intensity value is traceable to the CIE127-2007 compliant national standards. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device Typ.
PAGE 3
Super Bright Yellow KCPSC04-107 SPEC NO: DSAG7187 REV NO: V.9A DATE: APR/07/2013 PAGE: 3 OF 5 APPROVED: WYNEC CHECKED: Joe Lee DRAWN: Q.M.
PAGE 4
KCPSC04-107 Recommended Soldering Pattern (Units : mm; Tolerance: ± 0.15) Reel Dimension Tape Specifications (Units : mm) SPEC NO: DSAG7187 REV NO: V.9A DATE: APR/07/2013 PAGE: 4 OF 5 APPROVED: WYNEC CHECKED: Joe Lee DRAWN: Q.M.
PAGE 5
PACKING & LABEL SPECIFICATIONS KCPSC04-107 Detailed application notes are listed on our website. http://www.kingbright.com/application_notes SPEC NO: DSAG7187 REV NO: V.9A DATE: APR/07/2013 PAGE: 5 OF 5 APPROVED: WYNEC CHECKED: Joe Lee DRAWN: Q.M.