Datasheet

PHOTOCOUPLER
KB814
SPEC NO: DSAD1533 REV NO: V.3 DATE: JUN/19/2003 PAGE: 6 OF 8
APPROVED: J. Lu CHECKED: Tracy Deng DRAWN: Y.H.LI
Cycle One cycle allowed to be dipped in solder including plastic nold portion.
Rosin flux containing small amount of chlorine
(The flux with a maximum chlorine content of 0.2 Wt % is recommended.)
even if the voltage is within the absolute maximum ratings.
Be aware that power is suddenly into the component any surge current may cause damage happen,
2.Cautions regarding noise
Avoid removing the residual flux with freon-based and chlorine-based cleaning solvent.
(2) Cautions
Fluxes
Flux
Voltage vs. Forward Current
260 or below (molten solder temperature)
1.Recommended soldering conditions (Dip soldering)
Less than 10 seconds.
Temperature
(1) Dip soldering
Time
* NOTES ON HANDLING
Fig. 11 Collector-emitter Saturation
°C