User Guide

Page 10
1. Use the arrow buttons on your remote to
highlight the letter group that includes the
rst letter of the state you are currently in.
Press SELECT on your remote.
When all equipment is properly connected and turned on, the Mobile Antenna Setup screen will
display. (It may take up to two minutes to display.)
Note: If the Mobile Antenna Setup screen does not display, press MENU, 6, 1, 1 on your
remote. Highlight the “Check Switch” button then press SELECT on your remote.
STANDARD KING TAILGATER OPERATION
IF THE RECEIVER IS NEW AND UNACTIVATED, YOU MUST COMPLETE
THE STEPS ON PAGES 6-9 FIRST!
IN STEPS 1-5, DO NOT BLOCK THE KING
TAILGATER’S LINE OF SIGHT TO THE SATELLITES
IN THE SOUTHERN SKY AT ANY TIME!
IMPORTANT!
If you move the antenna unit any
time during or after the scan,
you will have to repeat steps 1-5.
NOTE:
Even you can block signal if you are
standing too close to the antenna unit.