Use and Care Manual
Page 7
1. Turn on the TV and satellite receiver.
2. Press POWER to turn on KING Quest controller. Wait for the COAX CONNECTION light to stop
ashing and remain on.
3. Press SCAN. The antenna will scan and locate all of the appropriate satellites before completing
the search process.
After the satellite acquisition process is complete, specic SCAN PROGRESS lights will turn on
to show which satellites have been found.
4. GO TO NEXT PAGE TO CONFIGURE RECEIVER.
7 BELL: INITIAL SCAN AND RECEIVER CONFIGURATION
IMPORTANT!
Any tall objects can block
the signal from reaching
the antenna.
Place the antenna unit in a position with a clear view of
the southern sky to scan for the satellites.
Place the KING Quest on a stable and reasonably level surface with a clear view of the southern sky.
When placing the KING Quest in position, be sure surface is dry and free of loose dirt or sand.
IF YOU CHOSE DISH MODE, SKIP THIS SECTION AND GO TO SECTION 10.
PLEASE BE PATIENT! This initial scan may take up to 15 minutes to complete. After this initial scan,
subsequent scans may take as little as 2 minutes, but may occasionally take up to 10-15 minutes.
Bell TV