Use and Care Manual
Page 6
1. Press POWER to turn on the controller. Wait for the lights to stop ashing and for the COAX
CONNECTION light to remain on.
2. Press and hold SCAN for ve seconds. The COAX CONNECTION light and the SCAN
PROGRESS lights that indicate the currently selected service will begin ashing.
3. Press SCAN repeatedly to scroll thru the available service options.
4. When the correct lights turn on to show your desired satellite conguration, press and hold SCAN
for ve seconds to save in memory.
All SCAN PROGRESS lights will turn off and the COAX CONNECTION light will stop ashing
and remain on.
5. Press and hold POWER to turn off the controller. Bell go to section 7, DISH go to section 10.
The KING Quest is factory preset for BELL HD AND SD (satellites 82 and 91).
If this is your desired service option, you do not need to congure your antenna. Go to section 7.
If you wish to use the Bell SD service option (satellite 91), or the DISH mode, you will need to recongure the antenna
as shown below.
6 ANTENNA CONFIGURATION
To check which service is selected without changing it, perform steps 1, 2, 4 and 5.
DO NOT CHOOSE ANY GRAYED OUT SERVICE OPTION.