Use and Care Manual

Page 10
9 BELL: SECOND RECEIVER OPERATION
INITIAL SETUP FOR SECOND RECEIVER
1. With the antenna locked on the satellite
and the second receiver connected to the
antenna unit’s AUX port coax, use your
receiver’s remote control and press
MENU, 6, 1, 1 to display the
Point Dish screen.
2. Use the arrow buttons on the remote
to highlight “Check Switch.”
Press SELECT on your remote.
See the next page for downloading programming to the second receiver.
3. When test is complete, highlight “Done.”
Press SELECT on your remote.
Antenna locked on
and
receiver connected!
Receiver sold separately.
The receiver will perform a check switch test. This process can take a little while so
PLEASE BE PATIENT.
Bell TV