User Manual

Page 4
1. Press knob button and remove knob from enclosure base.
2. Route the coax thru the coax hole in the enclosure base. Place the
enclosure base around the adjustable connector and against ceiling.
(The enclosure base will seat around the centering ring on the adjustable
connector.) Fasten the enclosure to the ceiling with four included screws.
3. Press the knob button and push knob onto the end of the adjustable
connector. THE KNOB ONLY FITS ON THE END OF THE ADJUSTABLE
CONNECTOR IN ONE DIRECTION. Knob ts into the raised ring on the
enclosure.
Fasten knob to connector with screw.
4. Route the coax around the raised ring as shown and connect the
coax to the RF connector on the KING SureLock signal meter.
5. Optional: If desired, apply the decal to the enclosure cover.
6. Carefully align the cover and snap into place.
Make sure not to damage or bend LEDs
or pinch the coax cable.
IMPORTANT!
Before starting step 1, turn the adjustable connector (or extension if installed) in one direction until the antenna hits
the stop. Now turn the connector all the way in the other direction until the antenna hits the stop again
(slightly more than 360°).
THE ANTENNA MUST ROTATE FREELY THRU THE ENTIRE DISTANCE.
INTERIOR ENCLOSURE INSTALLATION