Product Manual
Page 6
Use the steps on page 5 to engage and disengage the antenna unit from the MB700.
If the antenna unit will be removed from the MB700 for any length of time, close the latching
mechanism (steps 3-5).
A padlock may be used instead of the safety pin to deter theft.
Lock not included. Recommended lock shank size = 5/16”.
7. Run coax from the antenna unit to the roof edge, then along edge to location where coax will
enter the vehicle. If installing an optional second receiver, run second coax to location where it
will enter the vehicle. Secure (both) coax to roof every 12-18 inches (see below).
8. Drill 3/4” hole through the roof and into the cabinet where receiver is stored. Feed coax down
through hole. Seal opening with roof-compatible sealant so that it is completely waterproof
(inside and outside of the 3/4” hole). Repeat for second coax if present.
9. Inside vehicle, make connections as shown in your owner’s manual.
IMPORTANT!
Roof hole(s) for wiring must be sealed
so they are completely waterproof.
Sealant must be roof-compatible.
The CE2000 Cable Entry Cover provides a
watertight seal where cables
penetrate the roof.
See www.kingconnect.com/
products/accessories.
OPERATING NOTES
IMPORTANT! Do not powerwash any part of the KING MB700.