Product Manual
Page 5
6. Connect coax to MAIN port and tighten connection. DO NOT OVERTIGHTEN.
If your antenna unit has two coax ports and you wish to use a second receiver, connect the
end of a second coax (sold separately) to the AUX port. DO NOT OVERTIGHTEN.
5. Engage the antenna unit into the MB700.
IMPORTANT!
The coax from the “MAIN” port must always
be connected to the main receiver.
Coax connections should be snug.
DO NOT OVERTIGHTEN COAX!
1. Insert front end of antenna unit into MB700.
2. Lower back of antenna unit into MB700.
3. Close the latch.
4. Snap retaining rod into retaining tab.
5. Insert safety pin.
6. Connect coax to antenna unit.
1
6
52
3
4
TO REMOVE ANTENNA UNIT:
Perform steps in reverse order (in step 4, press on retaining tab to release rod).