Product Manual

ManualsBrandsKing ManualsRV AccessoriesQuick-Release Roof-Mount Fixture for Portable Satellite TV Antennas

Quick Release Roof-Mount Kit

MB700

Thank you for purchasing a KING product!

The KING Quick Release Roof-Mount provides a convenient way

to securely mount your KING antenna to your vehicle,

yet still allows quick and easy removal for portable use.

Owner’s Manual

CONTENTS

INSTALLATION ............................................................................................... 2-5

OPERATING NOTES ......................................................................................... 6

LIMITED WARRANTY ....................................................................................... 7

IMPORTANT! Please read thru the installation instructions before beginning.

It is the responsibility of the installer to determine and supply

appropriate fasteners and roof-compatible sealant.

Summary of content (8 pages)

PAGE 1
Quick Release Roof-Mount Kit MB700 Owner’s Manual Thank you for purchasing a KING product! The KING Quick Release Roof-Mount provides a convenient way to securely mount your KING antenna to your vehicle, yet still allows quick and easy removal for portable use. CONTENTS INSTALLATION ............................................................................................... 2-5 OPERATING NOTES ......................................................................................... 6 LIMITED WARRANTY .
PAGE 2
INSTALLATION 1. Make sure you have the following tools and materials before starting. Many RVs are prewired with RG-6 coax cable for satellite antennas. Contact the manufacturer of your RV or your local RV dealer to verify where this cable is located. If prewired, run the existing coax cable from the prewire location in the roof to the antenna unit. When choosing the antenna unit location, make sure the prewiring will reach the antenna unit. ANTENNA UNIT LOCATION (See Illustration on next page) 2.
PAGE 3
ANTENNA UNIT LOCATION HEIGHT OF OBSTRUCTION APPROXIMATE MINIMUM DISTANCE TO EDGE OF ANTENNA UNIT 10” 8” 11” 10” 12” 12” 13” 14” 14” 16” 15” 18” 16” 20” Page 3
PAGE 4
3. Assemble the MB700. Press the (4) stringers into place and fasten with (4) included screws. Press the two sets of stringers together. IMPORTANT! The installer is responsible for determining and supplying the most appropriate fasteners to secure the MB700 to the roof, and for weatherproofing all holes with roof-compatible sealant. All holes and fastener heads must be sealed so they are completely waterproof. 4. Open the latching mechanism (see opposite page).
PAGE 5
. Engage the antenna unit into the MB700. 11. Insert front end of antenna unit into MB700. 44. Snap retaining rod into retaining tab. 22. Lower back of antenna unit into MB700. 55. Insert safety pin. 33. Close the latch. 66. Connect coax to antenna unit. TO REMOVE ANTENNA UNIT: Perform steps in reverse order (in step 4, press on retaining tab to release rod). 6. Connect coax to MAIN port and tighten connection. DO NOT OVERTIGHTEN.
PAGE 6
7. Run coax from the antenna unit to the roof edge, then along edge to location where coax will enter the vehicle. If installing an optional second receiver, run second coax to location where it will enter the vehicle. Secure (both) coax to roof every 12-18 inches (see below). 8. Drill 3/4” hole through the roof and into the cabinet where receiver is stored. Feed coax down through hole. Seal opening with roof-compatible sealant so that it is completely waterproof (inside and outside of the 3/4” hole).
PAGE 7
LIMITED WARRANTY KING MB700 Quick Release Roof-Mount Kits are thoroughly inspected and tested before leaving the factory, and are covered by the following limited warranty from the date of original purchase: • One-year parts warranty: The customer is not responsible for the cost of replacement parts if the original part is determined to be defective under the terms of the warranty. The customer is responsible for the cost of replacement parts after one year.
PAGE 8
Simply better, by design.™ 11200 Hampshire Avenue South, Bloomington, MN 55438 PH 952.922.6889 || FAX 952.922.8424 || kingconnect.