User guide

12
1.
2.
3.
4.
5.
1.
2.
3.
POOL FROG
®
Cycler Maintenance
Replacing the Control Dial O-Rings
Using a needle nose pliers,
find the snap ring tail located
at approximately the five
o’clock position under the
control dial.
Pull down and out of the
groove.
Using a large screwdriver,
loosen the control dial.
Carefully pry the dial until it
pulls out.
Carefully replace the rubber
o-ring without stretching it.
Apply silicone lubricant, that
came with your POOL FROG
XL PRO®, on o-ring.
Push control dial completely
into the housing and turn the
dial to setting 2.
Replacing Cap O-Ring
Lubricate o-ring often with
silicone lubricant that
came with your POOL FROG
XL PRO®. DO NOT USE
petroleum based lubricants.
Replacing Knobs
Replace knob in back or on cap
of both POOL FROG XL PRO
®
Cyclers by unscrewing old one
and screwing in new one.
Hold cap in front of you
upside down with the o-ring
groove facing up. Place one
end of o-ring into cap groove
at the point closest to you.
Hold o-ring down with the
thumb and index finger of
one hand.
Take hold of the far end of
the o-ring with the thumb
and index finger of the other
hand. Roll o-ring slightly
back towards you as you
stretch the o-ring into the
remainder of the cap groove.
12
Insert the non-lipped end
of snap ring into the groove
opening beginning at the
5 o’clock position and push
it up so that it threads itself
around the control dial.
6.
7.
Using a small screwdriver or
pointed tool to help guide it,
make sure the snap ring stays
in the groove as it is inserted.
Back of Cycler
Or top of cap
S
I
L
I
C
O
N
E
L
U
B
R
I
C
A
N
T
S
I
L
I
C
O
N
E
L
U
B
R
I
C
A
N
T