Owner manual

7
Replacing a POOL FROG® Mineral Reservoir
(POOL FROG Mineral Reservoirs MUST be Replaced Every Season)
1.
Check the top of the box and back label of product to make
sure you have the correct POOL FROG® Mineral Reservoir to fit
your POOL FROG® Cycler.
THE POOL FROG® MINERAL RESERVOIR MUST BE
REPLACED EVERY 6 MONTHS OR AFTER ONE POOL
SEASON WHICHEVER IS SHORTER.
IMPORTANT: Remove and read the
information card.
Please note: Complete instructions
for inserting a POOL FROG® Mineral
Reservoir, FROG BAM® and POOL FROG®
Bac Pac are included inside the POOL
FROG® Mineral Reservoir.
WARNING
USE ONLY the factory recommended replacement POOL
FROG® Mineral Reservoir, FROG BAM® and POOL FROG®
Bac Pac. DO NOT USE any other pac or bulk chemical
tablets in the POOL FROG® Cycler. Use of any other product
could result in damage to pool equipment or surface,
unsafe pool conditions, fire or explosion. Warranty will be
void if the correct POOL FROG® Mineral Reservoir, FROG
BAM® and POOL FROG® Bac Pac are not used.
2.
3.
Turn off pump and turn dial
to Setting 0. This reduces
the flow of water into the
unit when the cap is open.
4.
Open cap. Stand back
to avoid inhaling chlorine
fumes from the POOL
FROG Bac Pac.
5.
Find slot on side of
POOL FROG® Mineral
Reservoir and line
up with fin inside the
POOL FROG® Cycler.
Lower POOL FROG®
Mineral Reservoir
into POOL FROG®
Cycler until secure.
6.
A bove Ground Series 6100 (Order #01-12-6112)
Now Fits the Following Cyclers:
POOL FROG Series 5100, 5200 or 6100
Prevail Series 5770 or 5771
®