User Guide

®
In Ground, Off-line Installation – Model 430
PVC
CEMENT
Two
Scoops
PVC
CEMENT
P
I
P
E
T
H
R
E
A
D
S
E
A
L
A
N
T
P
I
P
E
T
H
R
E
A
D
S
E
A
L
A
N
T
P
I
P
E
T
H
R
E
A
D
S
E
A
L
A
N
T
P
I
P
E
T
H
R
E
A
D
S
E
A
L
A
N
T
1.
2.
3.
4.
5.
6.
Do NOT install an off-line
Cycler in-line as this Cycler is
different than an in-line unit.
Install off-line when
insufficient room for an inline
application. Install as far from
heater as possible.
MATERIALS NEEDED
PVC
Cement
Pipe Thread
Sealant
Two
90 Degree
Elbows
Two Male
Adapters
Two Reducer
Bushings
Four Hose
Clamps
Corrosion Resistant
Check Valve
#10 X 1 1/4" Phillips Pan
Head Screws with
Washers
OFF-LINE KIT
6' of
Tubing
Two
Scoop
Gaskets
Two Scoop Clamps
Included with Cycler
RECOMMEND
Can be installed with the water flow in either direction due to
its bi-flow control dial.
TOOLS NEEDED
Wrench
Screwdriver
Battery
Operated Drill
with 5/8" or 19/32" Bit.
Following pipe thread sealant
directions, brush sealant onto
elbow threads.
Following pipe thread sealant
directions, brush sealant onto
Cycler threads in both ports.
Brush sealant on threads of
both male adapters.
DO NOT USE TEFLON TAPE
as the threads on
these units are
not suitable for
this use and
leaking or bushing
failure could result.
Screw a male
adapter into each
port of Cycler and
hand tighten.
Completely tighten
turning 1 to 2
revolutions
with a wrench.
DO NOT OVER
TIGHTEN.
Following PVC cement
directions, brush PVC cement
on reducer bushings and
inside of male adapters.
Insert reducer bushing
into male adapter on both
sides. Hold in place 5 to 10
seconds to bond.
9
®
®