User Guide

Brush sealant on the
threads of both male
adapters.
DO NOT USE TEFLON
TAPE as the threads
on these units
are not suitable
for this use and
leaking or fitting
failure could result.
®
In Ground, In-line Installation – Model 400
PVC
CEMENT
P
I
P
E
T
H
R
E
A
D
S
E
A
L
A
N
T
PVC
CEMENT
Corrision Resistant
Check Valve
P
I
P
E
T
H
R
E
A
D
S
E
A
L
A
N
T
P
I
P
E
T
H
R
E
A
D
S
E
A
L
A
N
T
COPPER PIPE
W
a
t
e
r
C
Y
C
L
E
R
M
e
t
e
r
e
d
P
o
o
l
P
u
r
i
f
i
e
r
8
®
®
1. 2. 3.
4.
5.
6.
Do NOT install an in-line
Cycler off-line as this Cycler
is different than an off-line unit.
Install after all equipment and as far as possible from heater.
Do NOT install in copper pipe
as chemical corrosion occurs.
Leave 12" to
15" above
and around
Cycler to
allow room for
easy
replacement
of Cycler Pac.
12" to 15"
12" to 15"
MATERIALS NEEDED
PVC
Cement
Pipe Thread
Sealant
Two 2" Threaded
X 2" or 1 1/2" Slip
PVC Bushings
(not included)
#10 X 1 1/4" Phillips Pan
Head Screws with
Washers
RECOMMENDED
Use Phillips pan head
screws through the
mounting holes at the
Cycler base to secure the
Cycler into a treated
wood base.
Can be installed with the
water flow in either direction
due to its bi-flow control dial.
TOOLS NEEDED
Wrench
Hacksaw
Following pipe thread sealant
directions, brush sealant onto
Cycler threads in both ports.
Screw a male adapter
into each port of
Cycler and hand tighten.
Completely tighten
turning 1 to 2
revolutions
with wrench.
DO NOT
OVER TIGHTEN.
Following PVC cement
directions brush PVC cement
on to ends of pipe and the
inside of male adapters.
Insert PVC pipe into male
adapters. Hold in place
5 to 10 seconds to bond.
Isolating the Cycler by
installing a corrosion
resistant check valve is
recommended to protect
the equipment and
prevent discoloration of
pool surface.
®
®
®