User Guide

Apply teflon tape to the
threaded end of both hose
adapters.
Screw adapters into
each end of Cycler.
Tighten turning 1 to
Attach the filter section of flex hose
to one hose adapter and the return
section of flex hose to the other hose
adapter with clamps and tighten with
screwdriver.
Above Ground, Base Installation – Model 100
The Cycler should always be installed
between the filter and pool (or between
heater and pool if applicable).
6
2 revolutions with wrench.
DO NOT OVER TIGHTEN.
TO POOL
PUMP
FILTER
HOSE
CLAMP
HOSE
ADAPTER
HOSE
CLAMP
HOSE
ADAPTER
TO POOL
1 1/2" OR 1 1/4"
FLEX HOSE
1 1/2" X 1 1/2" X 1 1/4"
HOSE ADAPTER
HOSE
CLAMP
FILTER &
PUMP
1.
2.
3.
4
5.
MATERIALS NEEDED
Two
Hose
Clamps
Corrosion Resistant
Check Valve
RECOMMENDED
OPTION
1 1/2" Male Adapter
(slip x MPT)
When installing with
hard PVC pipe, use
either a half union on
the outside port
threads or a bushing
on the inside port
threads.
#10 X 1 1/4" Phillips
Pan Head Screws with
Washers
Half Union
or
TOOLS NEEDED
Isolating the Cycler by installing a corrosion resistant check
valve is recommended to protect the equipment and prevent
discoloration of pool surface.
Teflon Tape
Two Hose Adapters
1 1/2" X 1 1/2" X 1 1/4"
Two Sections of
of 1 1/2" Flex Hose
(one provided with filter)
For better stability, Cycler may
be mounted on a base using
Phillips pan head screws.
Screwdriver
Wrench