FROG Leap Infuzer™ Mineral Pool Care System Model 7800 For Pools up to 25,000 Gallons infuzer System Includes the FROG Leap Anti-Bac Mineral Pac™ Patented Mineral Disinfectant Customer Service 800-222-0169 www.kingtechnology.
TABLE OF CONTENTS FROG Leap™ Introduction 3 Swimming Pool Tips 4 Start-up and Operation 5-6 Replacing FROG Leap Anti-Bac Mineral Pac™ 7 Using FROG Leap Depth Charge™, Reveille, Torpedo Pac™ 8 Using FROG Leap ALL-OUT!™ 9 Troubleshooting 10 Parts List 11 Replacing Control Dial O-Rings 12 Replacing Cap O-Rings and Knobs 12 Winterizing 13 Filter Installation 14 Base Installation 15 Warranty 16 For information on King Technology’s entire product line, visit our website at www.
Welcome to easier pool care courtesy of FROG Leap™. With FROG Leap™, your pool water will look and feel better without a lot of work or a lot of chlorine. This system† controls bacteria using a combination of minerals and reduced chlorine levels. Chlorine lasts 2X longer with FROG Leap™ Mineral System.* There are 4 main parts to the FROG Leap™ System: The FROG Leap Infuzer™, the FROG Leap Anti-Bac Mineral Pac™, FROG Leap ALL-OUT!™ (90-day Algae Preventative) and the FROG Leap Torpedo Pac™.
Swimming Pool Tips Start-up and Yearly Maintenance 1. Make sure the pool has adequate circulation. The pool water must completely circulate through the pump and filter at least 1 to 2 times per day. This usually requires 8 to 12 hours. Check with your dealer for the proper circulation time for your pool. 3. If your fill water is high in metals, use a sequestering agent or metal out product at start-up only before using the FROG Leap Anti-Bac Mineral Pac™.
Start-up and Operation - FROG Leap Anti-Bac Mineral Pac™ now with 25% More Water Polishers for easier start up. Add a stabilizer or conditioner to the pool at the beginning of the season if the stabilizer level is below 20 ppm. This will prevent chlorine burn off. Follow manufacturer’s directions carefully. 5. For a 90-day algae protection guarantee, insert FROG Leap ALLOUT!™ into FROG Leap Anti-Bac Mineral Pac™ in Infuzer. (See page 9 for directions.) 6. When chlorine reading is down to 1.
Start-up and Operation control dial by matching up the parameters of your pool on the chart below. THIS IS A STARTING POINT ONLY and may 7. Set need to be adjusted to fit your individual pool needs. See #8 below for directions. IMPORTANT: Pump run times less than 8 hours could result in under chlorination due to inadequate flow through the System.
Replacing a FROG Leap Anti-Bac Mineral Pac™ (FROG Leap Anti-Bac Mineral Pac™ MUST be Replaced Every Season) 1. SERIES 7800 (ORDER #01-12-7822) NOW FITS THE FOLLOWING SYSTEMS: FROG 4500, 5100, 5200, 6100, 6500 and 7100 Prevail 5770 and 5771 4. Turn off pump and turn dial to Setting 0. This reduces the flow of water into the unit when the cap is open. Check the top of the box and back label of product to make sure you have the correct FROG Leap Anti-Bac Mineral Pac™ to fit your FROG Leap Infuzer™.
Using FROG Leap Depth Charge™, FROG Leap Reveille™ or FROG Leap Torpedo Pac™ Avoid sparks, open flame or smoking when handling FROG Leap Depth Charge™, FROG Leap Reveille™ or FROG Leap Torpedo Pac™. REVEILLE FROG Leap Depth Charge™ 1. FROG Leap Reveille™ FROG Leap Torpedo Pac™ To remove colored caps, grab onto the lip of one cap with a pliers and pull up until cap releases. Repeat the process for the other cap.
Using FROG Leap ALL-OUT™ for a 90-Day Algae Protection Guarantee If you are not using FROG Leap ALL-OUT!™ proceed to inserting For a preventive dose add: FROG Leap Torpedo Pac™. See FROG Leap ALL-OUT!™ product •One FROG Leap ALL-OUT!™ for pools up to 15,000 gallons. labeling for complete directions for use (EPA Reg. No. 53735-9). •Two FROG Leap ALL-OUT!™ for pools between 15,000 & 30,000 gallons.
Troubleshooting For more in-depth troubleshooting, go to www.kingtechnology.com Problem 1. What do I do if the water looks cloudy? Remedy 1. Make sure your filtration system is working properly (i.e. clean filter, skimmer and pump basket). 2. Make sure circulation time is adequate – increase pump time if not. 3. Make sure the pool is properly balanced (see page 4). 5. Make sure pool has a free chlorine reading of 0.5 to 1.0 ppm. 4. Shock the water to eliminate build up of any organic matter. 6.
Parts List Model 7800 SILICONE LUBRICANT Included with FROG Leap Infuzer™ 7800 REF. # DESCRIPTION QTY. INCLUDED Replacement parts for FROG Leap Infuzer™ 7800 REF. # PART NO.
FROG Leap Infuzer™ Maintenance Replacing the Control Dial O-Rings 1. Center of locking pin Replacing Cap O-Ring 1. Hold cap in front of you upside down with the o-ring groove facing up. Place one end of o-ring into cap groove at the point closest to you. Hold o-ring down with the thumb and index finger of one hand. 2. Take hold of the far end of the o-ring with the thumb and index finger of the other hand.
Winterizing 1. 4. If FROG Leap Torpedo Pac™ still contains chlorine, wrap in plastic bag and store in shed or cool well-ventilated location away from children, pets, cars, motorcycles or anything metal that can rust, pit, etc. Make sure FROG Leap Torpedo Pac™ is away from open flame. 5. Remove the FROG Leap AntiBac Mineral Pac™ and discard in trash. Even if you hear spent minerals inside, it is no longer effective. Turn pump off and turn dial to Setting 0. 2. Remove cap. 3.
TOOLS NEEDED Filter Installation Screwdriver Pipe Wrench INCLUDED WITH FROG Leap Infuzer™ Pipe Thread Tape or Sealant 1. 2. Apply pipe thread tape or sealant to each threaded end of nipple. Screw one end of nipple into the filter return. Hand tighten. Finish tightening by turning 1 to 2 revolutions with wrench. DO NOT OVER TIGHTEN. One 6” X 1 1/2” TBE PVC Nipple 3. Screw either side of FROG Leap Infuzer™ on to open nipple end until upright and secure. 5.
TOOLS NEEDED Base Installation Screwdriver • Never install FROG Leap Infuzer™ before the heater. • Any additional sanitizing equipment that is installed with FROG Leap Infuzer™ must be installed after FROG Leap Infuzer™ (never before) on the return line to the pool. PUMP Pipe Wrench FILTER Materials Needed Pipe Thread Tape or Sealant TO POOL The FROG Leap Infuzer™ should always be installed between the filter and pool (or between heater and pool if applicable).
FROG Leap Infuzer™ Two-Year Limited Warranty King Technology, Inc. warrants to the original purchaser this unit will be free from any defects in workmanship and/or material, for a period of two (2) years from the date of original purchase. This warranty covers body, cap and control dial, but specifically excludes o-rings. King Technology at its option may replace any defective parts or the entire unit without charge after it is determined what is needed to correct any deficiency.
