Product Manual

LUBRICATION

Before every use and after every 8 hours of use, grease the spreader. Be sure that the grease

zerks are clean from dirt and debris before injecting with grease. Lubricate with (with a grade

II type tube grease) at the points shown in the picture, both sides of axle. The unit comes with

grease in the gearbox, there is a plug (see picture on left) on the bottom of the gearbox that

a flathead screwdriver will fit if you ever

need to add grease. When adding grease

to gearbox remove plug and pump full of

grease.

REPLACEMENT OF SPREADER VANES

In case the spreader vanes brake or get damaged, it is

necessary to replace them with new ones. Unscrew the

nut and replace the damaged vane. The nuts and bolts

must be of the same type of those prescribed from the

manufacturer.

STORAGE

Don’t wait until you are ready to use the spreader to do

the repairs and maintenance. It is best to repair and re-

place the damaged and broken parts before storing after

last use. So it will be ready for next use.

Store the spreader in a sheltered place away from atmospheric agents and protect it in order

to avoid deteriorations. The fertilizers are generally corrosive. For this reason it is important

that no particles of fertilizer remains on any part of the spreader for long periods of time.

Before storing for long periods,

- thoroughly wash the spreader and especially inside the hopper and spreading disc;

- look over the spreader thoroughly and check for structural damages, looking for deep abra-

sions in the paint;

- verify that the safety signs are on the spreader and readable, In case they are torn and un-

readable, replace with new ones.

- grease all mechanical parts.

- store spreader in a sheltered, dry place if possible.

SPARE PARTS

For the replacement of parts the customer must use original parts, ordering them from the

manufacturer or an authorized dealer.

When ordering parts it is necessary to have your model number.