Product Manual

HOW TO ADJUST THE SPREADING

The material spreading is regulated through the regulation lever that moves the open-

ing section on the bottom of the hopper. In order to carry out the regulation, after hav-

ing consulted the spreading table, according to the type of material to spread and to

the speed of pulling vehicle, it is necessary to move the lever “A” along the graduated

scale “E” and locking it in the chosen position with pin “D”.

In order to spread from both sides (ref. I), “A” and “B” levers must be in the

same position, connected through grip handle “C”. In order to carry out the

spreading only through the left side (ref. II), it is necessary to disconnect the

two levers removing the “C” grip handle, to set the lever “B” in the chosen posi-

tion, given by spreading chart, and to bring the lever “A” towards the higher

part (position1) in order to close the shutter of the right side. In order to spread

only to the right side (ref. III) you have to move lever “B” up, ( in position 1) and

regulate the quantity to spread with lever “A”.