Product Manual

FINISHING MOWER ASSEMBLY INSTRUCTIONS

STEP 1

With finishing mower still in crate, lay flat on a level surface. Remove the top & side sections of

the crate, leaving the finishing mower resting on the bottom section. Set aside PTO shaft and

tail wheel arm assemblies.

STEP 2

Insert tail wheel arm assemblies as shown in Figure A. (Note: Insert rear tail wheel arm as-

semblies first and adjust according to Figure C.) Front tail wheel arm assemblies should slide

into tail wheel arm holder until bottoming out. Tighten jam bolt and then jam nut.

STEP 3

Remove swivel links and lift pins that are wired on the lift arm “A” frame. Set aside for step 5.

STEP 4

Remove the 4 bolts from the lift arm “A” frame. (Note: There are 2 different lengths of bolts.)

STEP 5

Attach the swivel links in the center of each lift plate channel using the longer of the 2 bolts, on

each side as shown in Figure B.

STEP 6

Attach the other end of each swivel link to the outside lower hole on the lift arm “A” frame using

the shorter bolts as shown in Figure B.

STEP 7

Attach the Category 1 lift pins as shown in Figure B.

STEP 8

Tighten all nuts and bolts.