Instructions / Assembly

LIGHTING AND OPERATING INSTRUCTIONS
THE COOKER MUST NOT BE LIT UNTIL THE PRECEDING
PLACEMENT INSTRUCTIONS HAVE BEEN COMPLETELY FOLLOWED.
1. If your Jet Burner has a baffle over the jet tube, turn it away from the jet tube.
2. Make certain that the regulator control is turned to OFF by turning it counterclockwise until it reaches the
stop.
3. Open cylinder control valve by turning it counterclockwise as per the diagram (Figure 2).
4. Hold a multipurpose lighter as per Figure 3 or paperbook match as per Figure 4 over the jet pipe. Turn
the regulator control toward the ON position until ignition occurs. Turning the regulator control clockwise
increases the gas pressure to the burner and hence the flame size (Figure 2). Refer to Figure 5 for proper
flame emission.
When lighting the cooker, if ignition does not occur in 3 to 5 seconds, turn the regulator and cylinder valve
off. Wait 5 minutes for gas to disperse. Repeat procedure.
5. If your jet cooker has a baffle, turn it to desired position over the flame using a noncombustible cooking
utensil. The purpose of the baffle is to spread the flame across the bottom of the pot. When trying to reach
a boil with water using a large stock pot, do not use the baffle.
6. Always monitor the flame throughout the cooking process. If at any point in the cooking process the flame
is accidentally extinguished, immediately turn the regulator and cylinder valve OFF. Wait 5 minutes for gas
to disperse and relight the cooker according to the lighting instructions. (#1 - #5) in this section.
14
NEVER PUT HANDS OR FACE DIRECTLY OVER BURNER WHILE LIGHTING
OR WHILE THE APPLIANCE IS LIT.
Turn Cylinder Handle
toward ON
(Counterclockwise)
Next
Turn Regulator Control
toward ON
(Clockwise)
20LB. LP
GAS
CYLINDER
20LB. LP
GAS
CYLINDER
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
* Model may
vary from
picture