Product Manual B

C90PK, C90PKB, C90H/SPK AND C90SSPK ASSEMBLY

INSTRUCTIONS

a. Locate the three separate plates. Lay the plates on a flat surface as shown in Figure 1 below.

If one of the plates has a cutout along the inner edge, this plate must be installed around the

adjustable baffle’s extension when following the steps below. (Some units have been

designed with larger center cutouts and the baffle extension cutout has been eliminated from

the design. Some models may not include an adjustable baffle.)

b. Place the rounded inner edge of one plate against the vertical jet pipe in center of cooker.

The plate will fit around the appliance leg using the cutouts provided on the plate. Repeat

procedure with the second plate. Align the bolt holes of the first and second plate and attach

with bolt, lock washer and nut. Repeat procedure with third plate. Tighten all bolts/nuts.

Reference below Figure 2 for picture of a proper heat plate assembly.

Figure 1

Figure 2

Baffle Extension

Cutout

Leg

Cutouts

Bolt

Holes

HOSE ASSEMBLY INSTRUCTIONS

1. Wrench tighten the 3/8” female flare swivel to the brass adapter.

2. The hose to burner (brass adapter) connection must be tightened and leak tested.

3. Go to the Use and Care Section of this manual for further instructions.

* Models may vary from picture.

JET PIPE

3/8 FEMALE

FLARE SWIVEL

ORIFICE CAP

(DO NOT REMOVE THIS FITTING)

The orifice is the drilled hole in the brass cap

which should be pointing up directly into the jet pipe.

ADJUSTABLE REGULATOR

TYPE 1

CONNECTION

BRASS

ADAPTER

20 LB.

LP GAS

CYLINDER