Instructions / Assembly

14
LIGHTING AND OPERATING INSTRUCTIONS
THE COOKER MUST NOT BE LIT UNTIL THE PRECEDING
PLACEMENT INSTRUCTIONS HAVE BEEN COMPLETELY FOLLOWED.
NEVER PUT HANDS OR FACE DIRECTLY OVER BURNER WHILE LIGHTING
OR WHILE THE APPLIANCE IS LIT.
1. Make certain that the regulator control is turned to OFF by turning it counterclockwise until it reaches the stop.
2. Open cylinder control valve by turning it counterclockwise as per the diagram (Figure 2).
3. Hold a multipurpose lighter as per Figure 4 or paperbook match as per Figure 3 over one of the jet pipes. Lighting
one jet pipe will also ignite the other jet pipe.
CAUTION: Do NOT place hands or face directly over the jet pipes when lighting.
Turn the regulator control toward the ON position until ignition occurs. Turning the regulator control clockwise increases
the gas pressure to the burner and hence the flame size (Figure 2).
When lighting the cooker, if ignition does not occur in 3 to 5 seconds, turn the regulator and cylinder valve off. Wait 5
minutes for gas to disperse. Repeat procedure. Refer to Figure 5 for proper flame emission.
4. Always monitor the flames throughout the cooking process. If at any point in the cooking process the flames are
accidentally extinguished, immediately turn the regulator and cylinder valve OFF. Wait 5 minutes for gas to disperse
and relight the cooker according to the lighting instructions. (#1 - #4) in this section.
FIGURE 1
FIGURE 3
FIGURE 4
FIGURE 5
PAPER BOOK MATCH
MULTIPURPOSE LIGHTER
Turn Cylinder Handle
toward ON
(Counterclockwise)
Next
Turn Regulator Control
toward ON
(Clockwise)
FIGURE 2
ADJUSTABLE REGULATOR
20LB. LP
GAS
CYLINDER
20LB. LP
GAS
CYLINDER
* Models may vary
from picture.