Instructions / Assembly

LIGHTING AND OPERATING INSTRUCTIONS

THE COOKER MUST NOT BE LIT UNTIL THE PRECEDING

PLACEMENT INSTRUCTIONS HAVE BEEN COMPLETELY FOLLOWED.

1. Check the cooker to make sure that it is set up as per the diagram (Figure 1).

2. Make certain the manual valve(s) is turned to the “OFF” position by turning it clockwise until it reaches the stop position.

3. Open the cylinder control valve by turning it counterclockwise as per the diagram (Figure 2).

4. Insert a multipurpose lighter through the hole in the shroud as per Figure 3, or use a paper book match placed above

casting as per Figure 4. Turn the manual valve control toward the “ON” position until ignition occurs. Turning the manual

valve counterclockwise increases the gas flow to the burner and hence the flame size (Figure 2).

When lighting the burner, if ignition does not occur in 3 to 5 seconds, turn the manual valve(s) and cylinder control off

Wait 5 minutes for gas to disperse. Repeat procedure.

5. Check that the flame is blue and that the flames are emitted from every port in the casting (Figure 5). If not, rotate the air

shutter position until there is a blue flame. Opening the shutter too much will cause the flame to “Lift” off the burner.

If there is a yellow flame, or if some ports have no flame, this indicates there may be an obstruction in the venturi tube

or ports. Check the maintenance instructions on page 18 for more information regarding a yellow flame.

6. Always monitor the flame throughout the cooking process. If at any point in the cooking process the flame is accidentally

extinguished, immediately turn the manual valve(s) and cylinder valve OFF. Wait 5 minutes for gas to disperse and

relight the cooker according to the lighting instructions (#1 - #5) in this section.

NEVER PUT HANDS OR FACE DIRECTLY OVER BURNER WHILE LIGHTING OR

WHILE THE APPLIANCE IS LIT.

MULTIPURPOSE

LIGHTER

PAPERBOOK

MATCH

FIGURE 3

FIGURE 4

FIGURE 5

Air Shutter

FIGURE 1

* Model May

Vary From

Picture

Turn T-handle

toward ON

(Counterclockwise)

Turn Cylinder Handle

toward ON

(Counterclockwise)

MANUAL VALVE/

REGULATOR

FIGURE 2