Instructions / Assembly

ASSEMBLY INSTRUCTIONS

* Model May Vary From Picture

TOOLS REQUIRED:

ADJUSTABLE WRENCH

1. Place top half of unit on bottom half of unit as pictured. The crossbar of top frame should be located

on same side as U clips located on the bottom frame.

2. Insert four bolts through holes in top and bottom of unit. Wrench tighten with supplied lock washers

and nuts.

3. Insert axle through the holes located on bottom half of the unit. Place a washer over each end

of axle. Place wheels over each end of axle and tighten with supplied washers and nuts. See below

picture for proper assembly.

4. Attach the cylinder heat plate onto the crossbar as pictured using two bolts. Wrench tighten with

supplied lock washers and nuts.

5. Insert threaded ends of cylinder collar into crossbar as pictured. Wrench tighten with supplied lock

washers and nuts.

6. Attach the tank ring to the bottom half of the unit as per diagram using the U clips which are welded

to the outside of the frame.

Top Half

Cylinder Collar

Cross

Bar

Axel

Heat

Plate

Wheel

Tank

Ring

Bottom

Half

Bolt

Lockwasher

Nut