Instructions / Assembly

LIGHTING AND OPERATING INSTRUCTIONS
THE COOKER MUST NOT BE LIT UNTIL THE PRECEDING
PLACEMENT INSTRUCTIONS HAVE BEEN COMPLETELY FOLLOWED.
1. Make certain that the regulator control is turned to OFF by turning it counterclockwise until it
reaches the stop.
2. Open cylinder control valve by turning it counterclockwise as per the diagram (Figure 2).
3. Hold a multipurpose lighter as per Figure 4 or paperbook match as per Figure 3 over the jet
pipe. Turn the regulator control toward the ON position until ignition occurs. Turning the regulator
control clockwise increases the gas pressure to the burner and hence the flame size (Figure 2).
When lighting the cooker, if ignition does not occur in 3 to 5 seconds, turn the regulator and
cylinder valve off. Wait 5 minutes for gas to disperse. Repeat procedure. Refer to Figure 5 for
proper flame emission.
4. Always monitor the flame throughout the cooking process. If at any point in the cooking process
the flame is accidentally extinguished, immediately turn the regulator and cylinder valve OFF. Wait
5 minutes for gas to disperse and relight the cooker according to the lighting instructions. (#1 -
#4) in this section.
14
NEVER PUT HANDS OR FACE DIRECTLY OVER BURNER WHILE LIGHTING
OR WHILE THE APPLIANCE IS LIT.
* Model may
vary from
picture
FIGURE 1
PAPER BOOK MATCH
Turn Cylinder Handle
toward ON
(Counterclockwise)
Next
Turn Regulator Control
toward ON
(Clockwise)
20LB. LP
GAS
CYLINDER
FIGURE 2
FIGURE 5
FIGURE 3
FIGURE 4
FIGURE 5
MULTIPURPOSE LIGHTER