Product Manual

18
1625 ASSEMBLY INSTRUCTIONS
CONTENTS
(1) Cooker Frame
(4) Legs
(2) Leg Braces
(1) Flat Bar Casting Support Bracket
(1) Casting/Air Shutter
(1) Hose/Regulator
(1) Thermometer
(4) Bolts, Lockwashers and Nuts
TOOLS NEEDED
Adjustable Wrench
Screwdriver
1. Align the holes on the flat bar support bracket to the holes located on the windshroud of the appliance
(flat bar support bracket bolts to inside of shroud.) Tighten with supplied bolts, lockwashers and nuts
(4 sets.) See Figure 1.
2. Install the four legs into the top frame by matching the letters on the legs to the letters on the leg
receivers (for example: A to A, B to B, etc...) Snap in leg bolts through the receiving holes on the
frame. Make sure the leg bolts pop completely out and legs are securely locked in position. Legs
should be installed with leg brace receivers facing to the inside of the cooker. See Figure 1.
3. Insert both leg braces diaganolly into the leg brace receivers located on the inside of each leg. See
Figure 1. Make sure legs are locked in position and unit stands sturdily.
4. Go to pg. 9 for casting installation instructions.
5. Refer to Figure 1, page 10 for hose assembly instructions.
6. Go to the Use and Care section of this manual for further instructions.
Cooker Frame
Leg Braces
Windshroud
Figure 1
Leg Brace
Receiver
Leg
Leg
Receiver
Flat Bar Casting
Support Bracket
* Model May Vary From Picture
Bolt