Instructions / Assembly

10
1) Assemble bolts, washers and nuts as per diagram.
2) Wrench tighten. Make sure all bolt sets are used
and unit stands sturdily.
ASSEMBLY INSTRUCTIONS
CASTING INSTALLATION
CONTENTS
(1) Bottom Ring
(3) Legs
(1) Flat Bar Casting Support Bracket
(1) Shroud with Welded Top Ring
(1) Casting/Air Shutter
(1) Hose/Regulator
(3) Foot Extensions
(16) Bolts, Lockwashers and Nuts
TOOLS NEEDED
Adjustable Wrench
Screwdriver
* Model May Vary From Picture
Leg
Flat Bar
Casting
Support
Bracket
Bottom Ring
Shroud
with Welded
Top Ring
A) Remove top nut from casting bolt. Leave bottom nut attached and tightened (if applicable.)
B) Place the casting bolt through the hole on the flat bar casting support bracket as pictured
below. The venturi tube of the burner should be located underneath the windshroud.
C) Reinstall nut to casting bolt. Tighten. Check to see if casting is pointing straight up and is
sturdy.
Bottom Nut
(If Applicable)
Top Nut
Casting Bolt
Casting Bolt
Venturi Tube
Shroud
Flat Bar
Casting Support
Bracket
* Model May Vary
From Picture
1
2
3
4
Legs bolt to outside of bottom ring (3
bolts, nuts and lockwashers).
Legs bolt to inside of shroud (6 bolts,
nuts and lockwashers).
Foot extensions bolt to outside of
bottom ring (3 bolts, nuts and
lockwashers).
Flat bar casting support bracket bolts
to inside of shroud (4 bolts, nuts and
lockwashers).
Foot
Extension