Instructions / Assembly

10
11
22
44
33
1) Assemble bolts, washers and nuts as per diagram.
2) Wrench tighten. Make sure all bolt sets are used
and unit stands sturdily.
ASSEMBLY INSTRUCTIONS
CASTING INSTALLATION
CONTENTS
(1) Bottom Ring
(3) Legs
(1) Flat Bar Casting Support Bracket
(1) Shroud with Welded Top Ring
(1) Casting/Air Shutter
(1) Heat Plate
(1) Hose/Regulator
(16) Bolts, Lockwashers and Nuts
(3) Foot Extensions
TOOLS NEEDED
Adjustable Wrench
Screwdriver
Legs bolt to outside of bottom ring
(3 bolts, nuts and lockwashers).
Legs bolt to inside of shroud
(6 bolts, nuts, and lockwashers).
Foot extensions bolt to outside of
bottom ring (3 bolts, nuts and
lockwashers).
Flat bar casting support bracket
bolts to inside of shroud
(4 bolts, nuts and lockwashers).
* Model May Vary From Picture
Leg
Flat Bar
Casting Support
Bracket
Bottom Ring
Foot Extension
Shroud
with Welded
Top Ring
A) Remove top nut from casting bolt. Leave bottom nut attached and tightened (if applicable.)
B) Place the casting bolt through the hole on the at bar casting support bracket as pictured
below. The venturi tube of the burner should be located underneath the windshroud. Place
the heat plate onto the casting bolt beneath the at bar casting support bracket.
C) Reinstall nut to casting bolt. Tighten. Check to see if casting is pointing straight up and is
sturdy.
Bottom Nut
(If Applicable)
Top Nut
Casting Bolt
Casting Bolt
Venturi Tube
Heat Plate
Shroud
Flat Bar
Casting Support
Bracket
* Model May Vary From Picture