! ! Remote Not Available With Certain Models ! ! ! ! ! ! ! . ! ! FOR RESIDENTIAL ONLY RATED FOR INDOOR OR WELL PROTECTED OUTDOOR AREAS. Rev 4.14.
Rev 4.14.
Minimum Clearances to Combustibles in Inches |--------Side--------| Min. Mtg. Mounting Angle Front Behind End Top Below Height 0° 1'7" 1'7" 1'7" 9.4" 7'9" 7'9" 45° 3'3" 6.5" 1'7" 1'7" 7'9" 7'9" NOTE: Ensure that building materials with a low heat tolerance (i.e, awnings, fabrics, plastics, sprinklers, insulation, etc.) are protected against degradation. This may require the heater to be mounted at a distance in excess of the published clearances to combustibles.
Heating Application Chart Series Heater Wattage RK 1500W Minimum Lamp Mounting Height Quantity (Ft) 1 Recommended Mounting Height [Dim. A] Recommended Distance Between Heaters (Ft)* [Dim. B] 8' to 9' 5' to 10' 7'9"' NOTE: Minimum Clearances to combustibles published in this manual and on safety labels must be maintained at all times. Factory recommended mounting heights are listed as a guideline. If infrared heaters are mounted too low or too high, they may result in discomfort or lack of heat.
Heater Dimensions Mount Heater Level -End to End- Series RK - 1 Lamp A 7.5” - 8.25” C 24” Heater Dimensions 12.62” 5.38” 6.41” Rev 4.14.
Rev 4.14.
Rev 4.14.
! ! Rev 4.14.
King Model Volts Phase Wattage Lamps Amps Accessory RK2015-RMT-BLK 208 1 1500 1 7.2 Remote Control RK2015-BLK 208 1 1500 1 7.2 On/Off Switch RK2415-RMT-BLK 240 1 1500 1 6.3 Remote Control RK2415-BLK 240 1 1500 1 6.3 On/Off Switch Product Size Weight (Lbs) 24.5" x 6.5" x 5.25" 6.68 RATED FOR INDOOR OR WELL PROTECTED OUTDOOR AREAS. Rev 4.14.
1 2 3 4 5 6 Rev 4.14.
Step 1: Mark hole locations on the mounting surface with spacing as shown. Step 2: Select fasteners and anchors of appropriate type sufficient for your specific wall type (Not provided). Drill holes on your indicator marks. Step 3: Insert wall anchors into holes. Step 4: Secure wall brackets to wall using 2 screws each. Make sure fasteners are suitable for your application. Step 5: Secure small brackets to heater using the supplied Eye Nuts.
1. Use only noncombustible materials for suspending hangers and brackets. 2. A minimum No. 2 chain with a working load limit of 115 lbs. is required. 3. Secure chain to heater using the provided eye nuts as attachment points. 4. Heaters must not be supported by electric supply lines and must be suspended from a permanent structure with adequate load capacity. Rev 4.14.
NOTE: You maybe required to add an additional junction box to the wiring box if additional wires are installed. 1500W Model Rev 4.14.
Fig. 1 Fig. 2 Rev 4.14.
Rev 4.14.
